Important Notes & Warnings
Rover Unit power input: 5V - 12.6V max (3s Lipo supported). Any power range above 12.6V will burn the device.
The temperature will rise when the Rover Unit is connected with the Ground Station. The temperature of the Rover Unit can be checked on the Ground Station side, and should e lower than 70°C. If the temperature is over 70°C with normal use, installing a active cooling fan is recommended.
Never power the Rover Unit without the antennas plugged in. Powering on the Rover Unit without the antennas plugged in will result in overheating.
Feature | Specification |
Frequency: | 2402MHz - 2483MHz |
Transmit Power: | FCC 23dbm, CE 29dbm, SRRC 20dbm, MIC 20dbm |
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following conditions:
this device may not cause harmful interference.
this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interface by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician of help.
FCC & IC Radiation Exposure Statement:
This equipment complies with the FCC and Canada radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
For Air Unit: The equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.
Last updated