Air Unit Interface & Installation
Last updated
Last updated
HDMI 2: Micro HDMI, for video input
HDMI 1: Micro HDMI, for video input (preferred)
Power: 6V - 12.6V max (3s Lipo supported) power input *avoid sharing BEC with servos
Micro USB: For debug or upgrade, support OTG
Pair/Reset: For pairing and rest
LED 1,2: To indicate pairing status and transmission status
UART: 3.3V / 5V UART
S.bus: Tow 3.3V RC output
Antenna 1,2: MMCX, for signal transmission and communication
Mount the Rover Unit securely to the drone
Choose the best position to attache the rover unit antennas.
Connect the antennas to ANT 1, ANT 2 (MMCX) on the Rover unit. There shall be no metal parts or any conductor attached to the antennas.
Connect S.bus on the Rover Unit to the RC IN on the Flight Controller.
Connect UART on the Rover unit to the TELEM 1 or TELEM 2 on the Flight Controller.
Connect 5V - 12.6V max (3s Lipo supported) battery to the power input on the Rover Unit.
Connect a camera to HDMI 1 (preferred) on the Rover Unit. If you are sing two camera, connect the second camera to HDMI 2. You may switch from Stream 1 and Stream 2 on the Ground Station to display the corresponding video stream.
